Cisco D9854 Installation And Operation Manual page 111

Setup Menu: Services,
AUDIO
Aud#
Description:
Parameters:
Stereo/Mono
Description:
Parameters:
AC3 Compression
Description:
Parameters:
Left (dB)
Description:
Parameters:
Right (dB)
Description:
Parameters:
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Continued
This is the audio output number to which all settings on the two
audio menus will apply.
1 or 2. When you change this option on one of the Audio Menus, it
changes on the other as well. The two audio (Aud#) menus allow
you to configure the two balanced audio outputs on the rear panel
(Audio 1 and Audio 2), known in the receiver as Aud1 and Aud2,
respectively.
This setting configures how audio received on the audio input is
handled.
Stereo (Left and Right are passed directly through to Left and
Right), R-MONO (Right is passed to both the Left and Right), L-
MONO (Left is passed to both the Left and Right), and Mixed (Left
is passed to both the Left and Right, and Right is passed to both the
Left and Right).
This is only applicable if the received signal is Dolby Digital (AC-3).
This specifies the Dolby Digital (AC-3) Compression range of the
received audio.
Line Mode, Custom 1, Custom 0 or RF Mode. RF Mode is
recommended for analog cable modulators.
This is the volume adjustment for the Left audio channel.
-6.0 dB to +6.0 dB. Any value can be entered with the numeric
keypad (in the appropriate range), but the UP and DOWN arrows
will make increments/decrements at 0.5 dB steps.
This is the volume adjustment for the Right audio channel.
-6.0 dB to +6.0 dB. Any value can be entered with the numeric
keypad (in the appropriate range), but the UP and DOWN arrows
will make increments/decrements at 0.5 dB steps.
4-49