Cisco D9854 Installation And Operation Manual page 212

Setting up Cueing Parameters,
7. Select the Relay Mode that can be programmed to respond to an Alarm state, or
the state of one of the eight cue trigger pins. The response is generated at the
Cue Tone/Relay output on the rear panel of the receiver. The following table
shows what the possible field settings are and their relationship to the receiver
output:
8. Select one of the Cue Trigger Bits corresponding to the Cue Trigger port pins (1
to 8).
9. Click Save.
5-48 Model D9854 Advanced Program Receiver Installation and Operation Guide
Continued
Relay Condition
Mode
Unit Power Off
Alarm State
Alarm
No Alarm
Trigger Active (selected in
PNC)
Inactive
Relay Contact
NC - C C - NO
Open Close
Open Close
Close Open
Close Open
Open Close
4021470 Rev D