Connecting The Rf Cables To The Chassis; To Connect Rf Cables For Each Module - Cisco Prisma II Installation And Operation Manual

Connecting the RF Cables to the Chassis

To Connect RF Cables for Each Module

Complete the appropriate procedure below to connect RF cables for the module.
Note: This procedure assumes that the chassis is mounted in a rack.
Standard Prisma II Chassis
Note: This procedure assumes a host module with receivers in both lower and upper
half-slot positions. If only one receiver installed, it is not necessary to connect RF
cables for the unused position.
1 Locate the RF ports on the chassis connector panel. The connector panel is on the
front of a front-access chassis, and on the rear of a rear-access chassis. The figure
below shows the connector panel for a rear-access chassis.
2 Connect RF cables to the Port A and Port C connectors for the chassis slot in
which the host module will be installed. These are the RF output connections for
the module in the lower half-slot position. Hand-tighten the connectors.
Route the RF cables from Ports A and C (for the lower half-slot module) to the
3
appropriate RF destinations.
78-4015908-01 Rev F

Connecting the RF Cables to the Chassis

19