D9858 Transcoder Alarm Messages; Alarms - Cisco D9858 Installation And Configuration Manual

Chapter 6 Service and Maintenance

D9858 Transcoder Alarm Messages

The Alarm LED on the front panel indicates whether the unit has triggered an alarm
or warning. A solid red signal for five seconds indicates a warning, and a flashing
red signal indicates an alarm. For more information, see About the Front Panel (on
page 34).
The status of the D9858 transcoder and its immediate surroundings is reported to the
front panel in the form of messages and alarms. You can enable or disable messages
in the Alarm/Warning settings.
The following table shows an alphabetical list of the available messages and their
default alarm status. The Set Messages and Clear Messages are displayed in the
Warning History when the messages are set or cleared respectively.
Note: Only alarm conditions can be used to trigger rear panel relays to control
external alarm equipment. Warnings are not associated with relay operations.
We recommend that you collect the debug support data prior to contacting Cisco
customer support for any D9858 issues.

Alarms

Alarm Message
Type
PSB non- Set
compliant
272
Message Cause/Remedy
PROD incomplete Cause: Production
or PSB non- Access Reset
command was not
compliant
issued after
production
programming was
completed.
Remedy: The
Access Reset
command should
be issued by the
user with PROD
credentials if the
device has not yet
been shipped to the
customer.
Otherwise, the
customer must
reset credentials
using the front
panel.
Description Severity
Device is in Major
the WEAK
state after
production
programming
is complete.
ID
900