Charging Fault; Fast Charge; Assemble The Srx-Sl Headset; Sharing The Srx-Sl Headset - Honeywell SRX-SL User Manual

Charging Fault

If the LED and Tones
• Unplug the SRX-SL headset from the charging cable and plug back in.
• Verify the temperature is within the safe charging range for normal charging: 32°F to 104°F (0°C to 40°C). If not, move
the headset to a different area and allow it to heat or cool to an allowable charging temperature.
• If the fault persists, contact

Fast Charge

If the temperature is 32°F to 95°F (0°C to 35°C), the SRX-SL supports fast charging. Fast charging provides 75% of the
battery capacity in less than one hour of charging.
• If the temperature rises above the fast charge threshold (95°F or 35°C) the SRX-SL headset reverts to normal charging
as long as the temperature stays below 104°F or 40°C.
• The 75% capacity is measured from a battery that has reached the point of software shutdown voltage.
Not all chargers support fast charging. For best results use the Honeywell supplied charger. A computer port may provide
sufficient power for fast charge.

Assemble the SRX-SL Headset

The SRX-SL headset consists of an eModule (electronics module) and a headband.
Align the notches on the eModule and the headband and snap together.

Sharing the SRX-SL Headset

By separating the parts of the modular SRX-SL headset, operators can share electronics modules in a multi-shift operation.
• The electronics module detaches easily from the headband.
• The electronics module can be disinfected with an alcohol wipe.
Pair the SRX-SL Headset Using Bluetooth
The SRX-SL enters pairing mode as soon as it is powered on.
• The headset is then discoverable and connectable.
• The headset does not automatically reconnect with the last device (or devices) it was paired with previously.
• Once the SRX-SL headset is powered on, initiate the discovery and pairing process on the computer to which the headset will
be connected.
If the SRX-SL headset is not connected, it powers off after 10 minutes in the disconnected state to preserve battery life.
If the USB cable is attached to charge the internal battery, the SRX-SL headset disconnects (if connected) and battery charging
begins.
2 - 2
(see page 1-3) indicate a charge fault:
Customer Support (see page 3-1).