Screen Control - Honeywell Thor VM2 User Manual

Screen Control

(Start) > Control Panel > Screen (Classic View)
Set screen properties for the Thor VM2.
Factory Default Settings
Screen Blanking (Blackout)
Enable screen blanking
Screen on delay (ms)
COM Port
Current Level
LCD Brightness (%)
Screen Blanking
Screen blanking allows the Thor VM2 display to automatically be turned off whenever
the vehicle is in motion.
Use the Screen on delay to specify the period of time in ms (milliseconds) between
when the vehicle stops and the Thor VM2 screen turns on. For example, use the delay if
the switch end of the cable is attached to the vehicle's accelerator pedal. Release of the
accelerator may mean the truck is coasting to a stop rather than stationary. Configure
the delay to allow time for the vehicle to coast to a stop. The default value is 1000 ms.
Specify the COM Port to which the screen blanking cable is attached. If a COM port is in
use by another application, that COM port is grayed out and cannot be selected for
screen blanking.
Do not enable Screen Blanking until the cable is properly connected to the
specified COM port.
To disable screen blanking, uncheck the Enable screen blanking checkbox.
194 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
Enabled
1000
COM1
100