Honeywell Thor VM2 User Manual page 107

6. Provide mechanical support for the cable by securing it to the vehicle structure at
7. Connect the watertight connector end of the power cable to the Thor VM2 dock
8. Secure the power cable to the Thor VM2 using the
9.
10. If using the
11. Press the
12. Press the
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
approximately one foot intervals, taking care not to over tighten and pinch conduc-
tors or penetrate outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely.
Place Thor VM2 in the
Screen Blanking
previously installed.
Power Switch
Power Button
Dock.
feature, install the screen blanking box or switch if not
on the back of the Thor VM2 dock.
on the front of the Thor VM2 to turn on the Thor VM2.
Strain Relief Cable Clamps.
107