Launching Configuration Cloning Utility Gui - Honeywell Thor VM2 User Manual

Launching Configuration Cloning Utility GUI

To launch the Client Configuration Utility follow the instructions below for the operating
system installed on the Thor VM2.
Windows Embedded Standard 2009
1. Locate the CCU icon either on the desktop or by selecting
2. Double-tap the icon to launch the CCU.
Windows Embedded Standard 7 and Windows 7 Professional:
1. Locate the CCU icon either on the desktop or by selecting
2. Right click on the icon.
3. Select Run as administrator to launch the CCU.
If a User Account Control message is displayed, you must allow the CCU to make
changes to the computer.
Windows Embedded Standard 2009
1. Locate the CCU icon either on the desktop or by selecting
2. Double-tap the icon to launch the CCU.
Windows Embedded Standard 7 and Windows 7 Professional:
1. Locate the CCU icon either on the desktop or by selecting
2. Right click on the icon.
Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
> Honeywell > Configuration Cloning.
> Honeywell > Configuration Cloning.
It is necessary to run the CCU as an administrator because the CCU must be
able to access and make changes to the Windows registry.
Rather than selecting to run as administrator each time, right click on the
CCU icon and select Properties. Tap the Compatibility tab and check Run
this program as an administrator. This modification affects the current user
only unless Change settings for all users is tapped before changing the priv-
ilege level.
> Honeywell > Configuration Cloning.
> Honeywell > Configuration Cloning.
(Start) > All Programs
(Start) > All Programs
(Start) > All Programs
(Start) > All Programs
207