Honeywell Thor VM2 User Manual page 214

The example above imports RFTerm settings into a file named myfile.ccf.
CCU.exe -import -RFTerm-ThorVM3_Win7 -C:\myfile.ccf
The example above imports RFTerm and Honeywell control panel settings into a file
named myfile.ccf.
Example 3: Apply settings
CCU.exe -apply -reset -e:\myfile.ccf
Use this command line example to read the settings from the specified ccf file and
apply them to the Thor VM2 running the CCC.
Where:
apply directs the CCU to read the settings from the ccf file and apply them to the system
registry.
reset is optional. When -reset is specified, all setting are reset to their default values
before the customized settings in the ccf file are applied. Any prior changes made to
these settings on the Thor VM2 are lost. If -reset is not specified, only the changed val-
ues in the ccf file are applied. Any other setting previously made on the Thor VM2 are
retained.
E:\myfile.ccf is the path and filename of the ccf file containing the changes to be
applied. If the path is not specified, the ccf file must be located at C:\Windows\DDF.
Note: After using the -apply parameter, the Thor VM2 must be rebooted for the changes to take
effect.
CCU.exe -apply -e:\myfile.ccf
The example above applies the settings from the ccf file to the device leaving all other
settings untouched.
CCU.exe -apply -reset -e:\myfile.ccf
The example above resets all values to defaults then applies the settings to the device.
214 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide