Honeywell Thor VM2 User Manual page 88

5. Route the power cable the shortest way possible removing any left-over cable. The
6. Provide mechanical support for the cable by securing it to the vehicle structure at
7. Connect the watertight connector end of the power cable to the Thor VM2 dock
8. Secure the power cable to the Thor VM2 using the
9.
10. If using the
11. Press the
12. Press the
Once installation is complete, remember to start the Thor VM2 and select the desired
Power Scheme to enable Auto-On, Ignition Control or Manual Control of the Thor VM2
boot up process.
See the Power Schemes tab of the
Ignition Control Wiring Diagram
Ignition wire must be connected and either of the Ignition Control power modes must
be selected from the Power Schemes tab of the
switched vehicle power is available the Thor VM2 ignition signal wire can be connected
(less than 1mA over input voltage range) to the switched circuit to allow the Thor VM2 to
power on when the vehicle is switched on. When the vehicle is switched off, more
aggressive power management settings are enabled to preserve the vehicle battery
charge.
88 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
• Ignition Control Wiring Diagram
• Auto-On Control Wiring Diagram
• Manual Control Wiring Diagram
cable is rated for a maximum temperature of 105°C (221°F). Therefore, when
routing this cable it should be protected from physical damage and from surfaces
that might exceed this temperature. Cable should be protected from physical
damage from moving parts. Do not expose the cable to chemicals or oil that may
cause the wiring insulation to deteriorate. Always route the cable so that it does not
interfere with safe operation and maintenance of the vehicle.
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely.
Place Thor VM2 in the Dock
Screen Blanking
Power Switch
Power Button
feature, install the screen blanking box or switch.
on the back of the Thor VM2 dock.
on the front of the Thor VM2 to turn on the Thor VM2.
Power Options
Strain Relief Cable
control panel.
Power Options control panel. When
Clamps.