Honeywell Thor VM2 User Manual page 70

Step 1b – Mount RAM Clamp to Vehicle
Note: If you are using the RAM ball mount, please go to
you are using the RAM plate mount, please go to
Attach RAM
1. Determine the position for mounting the RAM clamp mount. The clamp mount can
2. Position the lower clamp piece below the beam. Align the bolts with the holes in the
3. Place the nylon locking nuts on the bolts and tighten the bolts.
Mounting Dimensions
Note: Drawing not to scale.
70 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
Ball.
be used on a beam (such as on a fork lift truck) up to 2.5" (63.5 mm) wide and
approximately 2" (50.8 mm) thick. The clamp may be attached to a thicker beam by
substituting longer bolts (not included). Be sure to position the RAM clamp mount
to allow access to the switches and ports on the bottom of the Thor VM2.
Bolts
Upper clamp piece
Lower clamp piece
Nuts
Position the upper clamp piece with ball on the beam. Place the bolts through the
holes in the upper clamp piece.
lower clamp piece.
2.56" /
1.84" (46.74mm)
65.02mm
Step 1a – Attach RAM Ball to
Step 1c – Attach RAM Plate to Vehicle and
Vehicle. If