Connect Serial Device; Connect Headset Cable - Honeywell Thor VM2 User Manual

Connect Serial Device

Note: Pin 9 of the desired COM port must be configured to provide +5V or RI as needed for the
connected device. See the
See
1. Seat the cable end connector firmly over the serial COM port on the dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Secure the cables to the Thor VM2 with
4. Connect the other cable end to the desired serial device.
Connect a Tethered Scanner
1. The scanner cable is attached to either the COM1 or COM2 port on the dock.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM2 is powered on, it provides power to the serial scanner.
4. Configure the Data Collection (DC) Wedge to manipulate scanned data as desired.

Connect Headset Cable

The CANbus/Audio connector supports a headset adapter cable or a CANbus cable. The
Thor VM2 does not support connecting audio and CANbus simultaneously.
See
1. Seat the D15 cable end connector firmly over the CANbus/Audio Connector on the
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
126 Thor VM2 with with Microsoft Windows 7 or Windows Embedded Standard User Guide
COM1 and COM2 Connector
Headphones
Microphone
CANbus / Audio Connector
dock.
Options control panel for details.
for connector pinouts.
Strain Relief Cable
To Audio cable
for connector pinouts.
Clamps.
To headset
To Audio
connector
on dock