Connect USB Host
D9 Connector
See
USB Connector
1. Seat the D9 connector firmly over the USB (or USB1) Connector on the Quick Mount Smart Dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB-host connector provides a connector for a USB device such as a USB thumb drive.
4. Secure the cables to the Thor VM3 with
Connect USB Client
D9 Connector
Connect Serial Device
See
COM1 and COM2 Connector
1. Seat the cable end connector firmly over the serial COM port on the Quick Mount Smart Dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Secure the cables to the Thor VM3 with
4. Connect the other cable end to the desired serial device.
Connect a Tethered Scanner
1. The scanner cable is attached to either the COM1 or COM2 port on the Quick Mount Smart Dock.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM3 is powered on, it provides power to the serial scanner.
4. Configure the Data Collection (DC) Wedge to manipulate scanned data as desired.
1 - 42
USB Host Connector
USB Client Connector
(page 5-6) for connector pinouts.
Strain Relief Cable Clamps
USB Host Connector
USB Client Connector
(page 5-5) for connector pinouts.
Strain Relief Cable Clamps
(page 1-23).
(page 1-23).