Backup/Restore - Mitsubishi Electric 800 Series Instruction Manual

(N) Operation via communication and its settings
5.15.9

Backup/restore

The GOT can be used for backing up inverter parameters and the data used in the PLC function of inverter.
The backup data stored in the GOT can be used to restore the data in the inverter.
Pr. Name
Network number (CC-
434
Link IE)
N110

Station number (CC-Link
435
IE)
N111


The setting is available in the inverter on which the FR-A8NCE is installed.
GOT2000
Connected devices
• To enable backup/restore, connect either the general-purpose inverter with the FR-A8NCE to a programmable controller
(master station) via the CC-Link IE Field Network.
NOTE
• The backup/restore function is enabled only when the inverter is connected to a master station programmable controller.
• For the details of the connected devices, refer to the GOT2000 Series User's Manual (Monitor).
Data to be backed up and restored
• The following data can be backed up and restored. The data other than listed in the following table cannot be backed up or
restored.
Inverter parameters
Parameters used for activating the PLC function
Programs (including SFCs) used in the PLC function
Global device comment information used in the PLC function
Function block source information
586
PARAMETERS
Initial
value
0 0 to 255
0 0 to 255
Ethernet
Restore
MELSEC iQ-R
Item
Setting
range
Enter the network number of the inverter.
Enter the station number of the inverter.
CC-Link IE Field Network
Backup
FR-A800 (with the FR-A8NCE installed)
Description