Trace Function - Mitsubishi Electric 800 Series Instruction Manual

Copying the PLC function project data to USB memory
• This function copies the PLC function project data to a USB memory device. The PLC function project data copied in the
USB memory device can be copied to other inverters. This function is useful in backing up the parameter setting and for
allowing multiple inverters to operate by the same sequence programs.
• Refer to page 58 for an outline of the USB communication function.
• The following data can be copied by copying the project data via USB memory device.
Extension
.QPA
.QPG
.C32
.QCD
.DAT
.TXT
NOTE
• If the project data of the PLC function is locked with a password using FR Configurator2, copying to the USB memory device
and verification are disabled. Also if set to write-disabled, writing to the inverter is disabled. (For the details of the PLC
function, refer to the PLC Function Programming Manual and the Instruction Manual of FR Configurator2.)
• The PLC function project data can be copied to a USB memory device by using the operation panel. For details, refer to the
instruction manual of the FR-LU08.
Parameters referred to
Pr.338 Communication operation command source
5.14.18

Trace function

• The operating status of the inverter can be traced and saved on a USB memory device.
• Stored data can be monitored by FR Configurator2, and the status of the inverter can be analyzed.
Pr. Name
1020
Trace operation selection
A900
1021
Trace mode selection
A901
1022
Sampling cycle
A902
1023 Number of analog
A903 channels
1024
Sampling auto start
A904
1025
Trigger mode selection
A905
File type
Parameter file
Program file
Function block source information
Global text comment information
Project management information
Copy information
page 301
Initial Setting
value range
0
1
0 2
3
4
0
0 1
2
2 0 to 9
4 1 to 8
0
0
1
0
1
0 2
3
4
(A) Application parameters
Copy from inverter to USB
memory device
Supported
Supported
Supported
Supported
Supported
Supported
Description
Without trace operation
Sampling start
Forced trigger
Sampling stop
Transfer of data to USB memory device
Memory mode
Memory mode (automatic transfer)
Recorder mode
Set the sampling cycle.
0: 0.125 ms, 1: 0.252 ms, 2: 1 ms, 3: 2 ms,
4: 5 ms, 5: 10 ms, 6: 50 ms, 7: 100 ms, 8: 500 ms, 9: 1 s
(Regarding the setting value "0 and 1", the cycle varies by the
control mode.)
Select the number of analog channels to be sampled.
Manual sampling start
Sampling starts automatically when the power supply is turned
ON or at a reset
Fault trigger
Analog trigger
Digital trigger
Analog or digital trigger (OR logic)
Both analog and digital trigger (AND logic)
Copy from USB memory
device to inverter
Supported
Supported
Supported
Supported
Not available
Not available
533
PARAMETERS
5
GROUP
A