Mitsubishi Electric 800 Series Instruction Manual page 50

2.6.3
Wiring of control circuit
Control circuit terminal layout
• Recommended cable gauge: 0.3 to 0.75 mm
2
AM 5 10E 10 SE SE

This terminal operates as the terminal FM.
Wiring method
• Power supply connection
Use crimp terminals and stripped wire for the control circuit wiring. For single wire, the stripped wire can be used without crimp
terminal.
Connect the end of wires (crimp terminal or stranded wire) to the terminal block.
(1) Strip the signal wires as shown below. If too much of the wire is stripped, a short circuit may occur with neighboring wires.
If not enough of the wire is stripped, wires may become loose and fall out. Twist the stripped end of wires to prevent them
from fraying. Do not solder it.
Wire strip length
(2) Use appropriate crimp terminals (ferrules, blade terminals, etc.).
Insert wires to the crimp terminal, and check that the wires come out for about 0 to 0.5 mm from a sleeve.
Check the condition of the crimp terminals after crimping. Do not use the crimp terminals of which the crimping is
inappropriate, or the face is damaged.
• Crimp terminals commercially available (as of January 2017)
Phoenix Contact Co., Ltd.
2
Wire gauge (mm )
With insulation sleeve
0.3 AI 0,34-10TQ
0.5 AI 0,5-10WH
0.75 AI 0,75-10GY
1 AI 1-10RD
1.25, 1.5 AI 1,5-10BK
AI-TWIN 2 0,75-10GY
0.75 (for two wires)

A ferrule terminal with an insulation sleeve compatible with the MTW wire which has a thick wire insulation.

Applicable to the terminals A1, B1, C1, A2, B2, and C2.
2
∗1
5 4 1 F/C +24 SD So SOC SD
RUN SU IPF OL FU PC RL RM RH RT AU
10 mm
Ferrule part No.
Without insulation sleeve
—
—
A 0,75-10
A 1-10
A 1,5-10
—
SIC S1 S2 PC A1 B1 C1
STP MRS RES
Damaged Crumpled tip
For UL wire
—
AI 0,5-10WH-GB
AI 0,75-10GY-GB
AI 1-10RD/1000GB
AI 1,5-10BK/1000GB
—
INSTALLATION AND WIRING
Control circuit
A2 B2 C2
SD SD STF STR JOG CS
Unstranded
wires
Wires are not inserted
into the sleeve
Crimping tool
model No.

CRIMPFOX 6

2
49