Commissioning The Elight - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)

5.6 Commissioning the eLight

If an eLight is installed, perform the following steps to configure it.
Procedure
Step 1 Ensure that the device address of the eLight actuator is the default value 2.
Toggle switches 1 to 4 of the DIP switch specify the device address in binary mode. ON
indicates 1, and OFF indicates 0.
Table 5-5 Setting a device address
Address
1
2
3
4
Step 2 Check the eLight function.
Table 5-6 Function check
Check Method
Choose Maintenance > Configuration
Wizard > Linkage Test > eLight
Controller Commissioning and click Test.
Step 3 Set eLight parameters.
1.
2.
Issue 06 (2020-04-22)
Toggle
Switch 1
ON
OFF
ON
OFF
Log in to the ECC800-Pro WebUI as an administrator.
In the Smart Module View, click Modify Device. Select an eLight actuator under
Devices, drag it to the access actuator to which you want to bind the eLight actuator, and
click Exit Edit Mode.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 2 Switch 3
OFF OFF
ON OFF
ON OFF
OFF ON
Normal Connection Status
The eLight is lit up in red, green, blue, and
white in sequence for 3 seconds
respectively, and then turns off.
5 Power-On Commissioning
Toggle
Switch 4
OFF
OFF
OFF
OFF
105