Access Control System; Aisle Access Control System - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Indica
tor
ALM

3.2.4 Access Control System

The access control system applies to equipment rooms, aisle containments, and cabinet doors.

3.2.4.1 Aisle Access Control System

The access control system collects and monitors data about the access of devices and
personnel to ensure access security.
Diverse access control devices such as the fingerprint and card reader with a keypad,
fingerprint and card reader, and card reader with a keypad are supported. Note that the
communication distance between an access control device and an access actuator should be
less than or equal to 5 meters.
Table 3-27 IC card chip specifications
Item
Chip model
Chip name
Chip type
Operating frequency
Issue 06 (2020-04-22)
Color
Red
If the IC cards used by the access control device need to be purchased, the IC card chip specifications
are as follows.
Copyright © Huawei Technologies Co., Ltd.
Name Status
intervals
Blinking at
short
intervals
Blinking
Alarm Steady on
indicator
Off
Specifications
S50
Mifare 1K (S50) card
Philips Mifare 1 IC S50
13.56 MHz
3 Device Description
Description
ECC800-Pro and the software
runs properly (the indicator
blinks at 0.5 Hz, on for 1s and
then off for 1s).
The smart ETH gateway does
not register with the
ECC800-Pro (the indicator
blinks at 4 Hz, on for 0.125s
and then off for 0.125s).
The indicator blinks at super
short intervals for 0.5s
(blinking at 10 Hz, on for
0.05s and then off for 0.05s)
and then turns off for 0.5s.
The cycle lasts for 10s.
A system failure alarm is
generated.
No system alarm is generated.
31