Huawei ECC800 User Manual page 216

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Figure 6-63 Transparent transmission channel
Table 6-49 Mapping between ECC800-Pro ports and port numbers
COM Port
Port Number
If a device is connected to a COM port on the UIM20A expansion module, the port number is
displayed on the WebUI after transparent transmission is enabled for the COM port and the
configuration is saved. For example, the port number of COM1 on UIM1 is 3215 in
6-63.


Step 4 Log in to the NetEco WebUI as an administrator.
Step 5 Choose System > Configuration > Data Center Planning. The Data Center Planning
window is displayed.
Step 6 Select the management domain to add a device. The management domain can be a
micro-module, container, cabinet or computer room.
Step 7 (Optional) If the management domain is a rack, click the management domain and choose
Design under
Step 8 In the lower-left corner of the page, click the Device tab. Click the drop-down list box in
Type and select Sensor.
Issue 06 (2020-04-22)
COM1
3211
 An ECC800-Pro can connect to a maximum of four UIM20A expansion modules with the
transparent transmission function.
 A UIM20A expansion module provides a maximum of eight COM ports with the transparent
transmission function.
If the port is set for the first time, you are prompted to set an authentication password.
On the Set Authentication Password tab page, set Authentication password and
Confirm authentication password and click Submit.
Enable security Authentication is set to Enable by default. If so, an authentication password must be
set. If Enable security Authentication is set to Disable, there is no need to set an authentication
password but this is risky.
If the port has been used, you will be prompted that the transparent transmission function
cannot be enabled and you need to select an idle port.
. The page for adding a device is displayed. Otherwise, skip this step.
Copyright © Huawei Technologies Co., Ltd.
COM2 COM3
3212 3213
6 Feature Description
COM4
3214
Figure
205