How Do I Add An Rs485 Device Connected To The Ecc800-Pro Through A Uim - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Path
Settings, click
Unhide All
Advanced Signals,
click Power Supply
Parameters.
Step 3 After setting all mandatory parameters, click Submit.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800-Pro WebUI, and drag the device to the
corresponding position in the Smart Module View pane based on the actual device layout.
8.1.30 How Do I Add an RS485 Device Connected to the
ECC800-Pro Through a UIM?
Prerequisites
This section uses the device (such as a T/H sensor, rPDU, cabinet electronic lock, and U-bit
manager) connecting to the COM1 port on the UIM20A expansion module as an example.
Procedure
Step 1 Set communications parameters on the device.
Table 8-44 Description of communications parameters to be set on a device
Parameter
Baud rate
Communications address
Step 2 Add the device to the ECC800-Pro WebUI.
1.
2.
Issue 06 (2020-04-22)
Parameter
Log in to the ECC800-Pro WebUI as an administrator.
Add the device.
Choose System Settings > Device Management and click Auto Discover Device to add
the device. The device connection information is displayed.
Copyright © Huawei Technologies Co., Ltd.
Setting
Recommended Value
This section uses 9600 as an example. Set this parameter
based on site requirements.
NOTE
For certain devices, this parameter does not need to be set.
This section uses 1 as an example. Set this parameter based on
site requirements.
8 FAQ
288