Huawei ECC800 User Manual page 295

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Step 2 Add the device to the ECC800-Pro WebUI.
1.
2.
Table 8-40 Parameter description for adding a device
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
4.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800-Pro WebUI, and drag the device to the
corresponding position in the Smart Module View pane based on the actual device layout.
Issue 06 (2020-04-22)
Log in to the ECC800-Pro WebUI as an administrator.
Add the device.
Parameter
Device attribute
Device type
Connect to
Communications
port
Device address
Click Test Connect to check whether the device connects to the ECC800-Pro properly.
− If the independent deployment AI_DI unit connects to the ECC800-Pro properly,
click Confirm. The connected devices are displayed in the Number of connected
devices list.
− If the connection is not proper, check that the cable is properly connected between
the device and the ECC800-Pro, that the device and ECC800-Pro are running
properly, and that the input parameters are consistent with the device parameters.
Choose Monitoring > System > ETH Converter Group > ETH Converter n >
Running Parameters and set Device name to ETH Converter n_Device name.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select the device attribute to be accessed from the
drop-down list box.
Select the device type to be accessed from the
drop-down list box.
Select the corresponding ETH converter from the
drop-down list box.
NOTE
Use the blinking function of the ETH converter to identify
the mapping between the device and the ETH converter.
COM1/COM2
This section uses 1 as an example. In practice, set
this parameter to be the same as the
communications address for the device.
8 FAQ
284