Huawei ECC800 User Manual page 122

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Step 2 Add a PDU2000.
1.
2.
Table 5-13 Adding a PDU2000
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
----End
Issue 06 (2020-04-22)
Figure 5-12 PDU2000-M (H) communications settings
− Press DOWN and UP to select the address to be set.
− Press MENU to confirm the settings.
If modification is successful,
displayed:
Log in to the ECC800-Pro WebUI as an administrator.
Add a PDU2000.
Parameter
Name
Device attribute
Device type
Connect to
Communications
port
Device address
Click Test Connect to check whether the PDU2000 connects to the ECC800-Pro
properly.
− If the connection is normal, click Confirm. The connected devices are displayed in
the Number of connected devices list.
− If the connection is abnormal, check whether the cable is properly connected to the
device, whether the device is running properly, and whether the parameter settings
are consistent with the device parameters.
Copyright © Huawei Technologies Co., Ltd.
is displayed: If modification fails,
Setting
Select PDU from the drop-down list box.
Select PDU2000-M (C) or PDU2000-M (H) from
the drop-down list box based on the actual device.
Select ETH Actuator1 from the drop-down list
box.
NOTE
The setting example indicates that the PDU2000 is
connected to the ETH Actuator1.
COM1/COM2
Enter the actual device address of the PDU2000.
5 Power-On Commissioning
is
111