Performing Startup Password Authentication (For Fusionmodule800) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
2.
----End
5.2 Performing Startup Password Authentication (for
FusionModule800)
When the system type is FusionModule800, perform the following steps to configure it.
Context



Issue 06 (2020-04-22)
Figure 5-3 WebUI login page
On the login page, enter the preset user name admin and preset password Changeme,
set the language, and click Log In.
 After the first login, change the password in time to ensure account security and prevent
unauthorized network attacks, such as data tampering. Huawei will not be liable for any security
issues caused by your failure to change the preset password in time or password loss after changing.
 Change the password of the user account periodically.
 Record and keep the password properly. If you forgot the password, you will be unable to log in to
the WebUI.
 When the event notification is configured and the password retrieval mode is configured under user
management, the password can be retrieved.
 An account is logged out due to timeout if no operation is performed within 10 minutes after system
login.
 A maximum of three users can log in to the ECC800-Pro WebUI at the same time.
The initial startup password authentication is required only during initial power-on
commissioning. If the authentication has been performed successfully, no authentication
is required afterward.
The startup password needs to be authenticated when you restore the default settings on
the WebUI or by pressing keys.
If the startup password authentication is not complete, the ECC800-Pro WebUI and app
cannot be used for commissioning.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
95