Setting And Adding Devices; Setting Integrated Ups Parameters - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
1.
2.
3.
4.
Step 2 Choose System Settings > Micro-Module Settings, and set Micro-Module Name so that
maintenance engineers will know the site where the fault has occurred.
1.
2.
----End

5.3 Setting and Adding Devices

5.3.1 Setting Integrated UPS Parameters

Procedure
Step 1 On the LCD screen displayed after the integrated UPS is started, enter the user name admin
and preset password 000001 to log in to the main menu screen.
Step 2 Tap
Step 3 Choose Settings > Communication, and set IP address assign to Automatic(DHCP).
Issue 06 (2020-01-02)
 By default, the system type displayed on the web page is the system type for the last operation.
Change the system type as required.
 If the system type is changed, the monitoring will restart and you can log in to the WebUI again after
3 minutes.
Select FusionModule1000A from the System Type drop-down list box.
Click Submit in the System Type area.
Figure 5-1 Setting the system type
Enter the current password in the Re-Authentication window, and click Submit.
Log in to the WebUI again to check that the system type has been changed.
On the WebUI home page, choose System Settings > Micro-Module Settings.
Change the value of Micro-Module Name and click Submit in the Site ID area.
If you enter incorrect passwords for three consecutive times, you will be locked out for 5 minutes.
to go to the Settings screen.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
91