Setting And Adding A Temperature And Humidity Sensor - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 5-19 Setting parameters for the hydrogen detection system
Path
Home >
Device
Management
3.
----End

5.3.22 Setting and Adding a Temperature and Humidity Sensor

Context
The BOM number for Polymer T/H sensors is 33010346, and the BOM number for Ambient
T/H sensors is 02310NBS.
Procedure
Step 1 Set the T/H sensor device address.


Issue 06 (2020-01-02)
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the hydrogen detection system connects to the
ECC800 properly.
− If the hydrogen detection system connects to the ECC800 properly, click Add
Device.
− If the hydrogen detection system does not connect to the ECC800 properly, check
whether the cable between the hydrogen detection system and the ECC800 is
connected properly, whether the hydrogen detection system and ECC800 are
running properly, and whether the input parameters are the consistent with the
hydrogen detection system parameters.
If the BOM number for T/H sensors is 33010346: Go to the LCD screen of the T/H
sensor. Press SET to go to the ADD screen, and set the device address to 1 by pressing +
or –.
If the BOM number for T/H sensors is 02310NBS: Set the T/H sensor device address
through the DIP switch on the T/H sensor.
Toggle switches 1 to 6 of the DIP switch specify the device address in binary mode. ON
indicates 1, and OFF indicates 0.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Hydrogen Monitoring System from the
drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
In this example, set Device address to 1. Set the
actual device address of the hydrogen detection
system during operations.
5 Power-On Commissioning
115