Adding A Camera On The Vcn500 - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Procedure
Step 1 Log in to the camera WebUI.
1.
2.
Step 2 Preview the site situation in real time and check the camera coverage through videos. Adjust
the lens if necessary.
Step 3 (Optional) If you use the SD card when no VCM500 is configured, set Video Plan and enable
the plan. To ensure sufficient storage capacity of the SD card, you are advised to enable the
motion detection function on the camera WebUI.
Step 4 Choose Configuration > Basic Configuration > Network, and set IPv4 Address, IPv4
Subnet Mask, and IPv4 Default Gateway for the camera according to the site plan.
----End

5.12.4 Adding a Camera on the VCN500

Prerequisites
The network communication between the VCN500 and the camera is normal.
Procedure
Step 1 Install Client/Server (C/S) client.
1.
2.
3.
4.
Step 2 Add a camera. For details, see
1.
Issue 06 (2020-01-02)
Configure the PC IP address and the camera IP address in the same network segment.
Enter the camera IP address (192.168.0.120 by default) in the address bar of the Internet
Explorer and press Enter button.
Enter the preset user name admin and the preset password HuaWei123, and click Log
In.
The version number is subject to the Quick Start delivered with the VCN500. The description and link in
this document are for reference only.
Obtain HW_IVS_Client.exe file from the CD-ROM delivered with the VCN50. You
can also log in to http://support.huawei.com/enterprise/ and search Client
Package.zip to download the corresponding version software.
Double-click HW_IVS_Client.exe, adopt the default installation mode, and wait until
the installation is complete.
Double-click the client program and on the login page, enter the user name Admin and
preset password Change_Me, and set Server address to the actual service IP address
(VCN500 IP address) and Port to 9900.
Click Log In to access the client home page. A message is displayed upon the first login
indicating that you should modify the password. After modifying the password, keep it
properly.
The IPC6325 camera is driven by the HWSDK protocol.
In Quick Setup area on the C/S client home page, double-click Add Camera.
Copyright © Huawei Technologies Co., Ltd.
Adding HWSDK- and ONVIF- Compliant
5 Power-On Commissioning
Cameras.
148