Adding An Ai/Di Sensor; Setting And Adding A Water Sensor (Wlds600) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Path
3.
----End

5.3.15 Adding an AI/DI Sensor

Context
This section describes the parameter settings in the scenario where the water sensorWLDS900
connects to the AI/DI_4 port and the temperature sensor connects to the AI/DI_2 port. If you
need to change a sensor port onsite, set parameters for the new port by following the method
described in this section.
Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_4 Port Settings.
Step 3 Set AI/DI_4 sensor to Enable, and click Submit.
Step 4 Set AI/DI_4 sensor name to Leak sensor WLDS900, check that AI/DI_4 sensor type is set
to Leak Sensor(Rope), and click Submit.
Step 5 Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_2 Port Settings.
Step 6 Set AI/DI_2 sensor to Enable, and click Submit.
Step 7 Set AI/DI_2 sensor name to Temperature sensor, check that AI/DI_2 sensor type is set to
NTC, and click Submit.
----End

5.3.16 Setting and Adding a Water Sensor (WLDS600)

Context
In this example, the WLDS600 water sensor (the BOM number is 33010465) is connected to
the COM1 port on the ECC800.
Issue 06 (2020-01-02)
Item
address
Click Connect Test to check whether the PDC DC meter connects to the ECC800
properly.
If the PDC DC meter connects to the ECC800 properly, click Add Device.
−
If the PDC DC meter does not connect to the ECC800 properly, check whether the
−
cable between the PDC DC meter and the ECC800 is connected properly, whether
the PDC DC meter and ECC800 are running properly, and whether the input
parameters are consistent with the PDC DC meter parameters.
Copyright © Huawei Technologies Co., Ltd.
Setting
actual configurations, set the device address for the
PDC DC meter based on the actual situation.
5 Power-On Commissioning
108