Setting And Adding A Pdu2000-M(C) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 5-7 Setting parameters for adding an ATS
Path
Home > Device
Management
3.
----End

5.3.11 Setting and Adding a PDU2000-M(C)

Procedure
Step 1 Set the PDU2000-M(C) monitoring parameters.
1.
2.
Issue 06 (2020-01-02)
Item
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the ATS connects to the ECC800 properly.
− If the ATS device connects to the ECC800 properly, click Add Device.
If the ATS device does not connect to the ECC800 properly, check whether the
−
cable between the ATS device and the ECC800 is connected properly, whether the
ATS device and ECC800 are running properly, and whether the input parameters are
the consistent with the ATS device parameters.
After the PDU2000-M(C) is powered on, the LCM displays the initialization screen.
Figure 5-5 PDU2000-M(C) initialization screen
Press MENU to enter the device communications address screen.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select ATS from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
In this example, set Device address to 1. Set the
actual device address of the ATS during operations.
5 Power-On Commissioning
102