Huawei ECC800 User Manual page 41

ECC800 Data Center Controller
User Manual
contact
Specifications
Table 3-21
Table 3-21 Access actuator technical specifications
Item
Power input
PoE port
Wireless
communication
AI/DI port
DO output
DI input
RS485 serial port
expansion
Wiegand
interface
BLINK button
Address DIP
switch
E-label
Indicators
Table 3-22
Table 3-22 Access actuator indicator description
Indicato
r
PWR
Issue 06 (2020-01-02)
contact
lists the access actuator environmental specifications.
Specifications
 DC input: Terminal, with input voltage of 36–60 V DC
 PoE input: One PoE port that complies with IEEE802.3at.
FE communication, 10/100M communications rate
One wireless communication port that complies with IEEE802.15.4,
mutual backup with FE communication
Two AI/DI ports, can connect to the fire alarm and exit button
One 12 V DC power output that controls magnetic locks, terminal
One DI input port for connecting to the door status switch
Two RS485 ports (one route) with the default communications rate of
9600 bit/s, physical port cascading supported (reserved function)
Two Wiegand interfaces, 12 V DC card reader operating power output;
two routes of card readers can operate at the same time.
 Press the button for less than 1 second to start blinking.
 Hold down the button for 1–5 seconds to search for a network and
start networking.
 Hold down the button for more than 6 seconds to clear network
parameters.
4-pin address DIP switch
Supported
describes the access actuator indicators.
Color Name
Green Power input
status indicator
Copyright © Huawei Technologies Co., Ltd.
status or magnetic lock port
Status Description
Steady on The power input is normal.
Off There is no power input.
3 Device Description
32