Huawei ECC800 User Manual page 30

ECC800 Data Center Controller
User Manual
Wireless Network Pairing (SW) and IP Address Reset (Default) Buttons
Table 3-7 Wireless network pairing and IP address reset buttons
Button
Name
SW
Default
Communications Ports
The ECC800 provides the following communications ports.
RJ45 port.
Issue 06 (2020-01-02)
Function Operation Description
Description
Wireless In non-wireless network (802.15.4)
network RF_Z pairing mode, press and hold down
(802.15.4) the button for 1.2s to 5s to enter the
pairing wireless network pairing mode.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 1.2s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
Press and hold down the button for
more than 6s to clear network
parameters.
WiFi pairing In non-WiFi pairing mode, press the
button button for less than 1.2s to enter the
WiFi pairing mode.
NOTE
This function is
supported only
in a scenario
where the WiFi
converter is
configured.
IP address reset Press and hold down the button for
3s. Then the IP address for the
ECC800 WAN_1 port will restore
to the default address 192.168.1.10.
Copyright © Huawei Technologies Co., Ltd.
3 Device Description
Indicator Status
The RF_Z indicator
is blinking at super
short intervals.
The RF_Z indicator
is blinking at long
intervals.
The RF_Z indicator
is on.
 When the system
enters the pairing
mode, the RUN
indicator is
steady on.

After pairing
succeeds, the
RUN indicator
blinks just as
before WiFi
pairing.

If pairing does
not succeed in 3
minutes, the RUN
indicator blinks
just as before
WiFi pairing.
None
Figure 3-4 shows the pins of the
21