Huawei ECC800 User Manual page 125

ECC800 Data Center Controller
User Manual
Table 5-20 Setting a device address
Address
1
2
3
4
Step 2 Add a T/H sensor.
1.
2.
Table 5-21 Setting T/H sensor parameters
Path
Home >
Device
Management
3.
----End
Issue 06 (2020-01-02)
Toggle
Switch 1
ON
OFF
ON
OFF
Log in to the ECC800 WebUI as an administrator.
Add a T/H sensor.
The setting example indicates that the T/H sensor is connected to the COM4 port on the
ECC800. If the T/H sensor is connected to another port, set the number of the connected
port.
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the T/H sensor connects to the ECC800 properly.
− If the T/H sensor connects to the ECC800 properly, click Add Device.
− If the T/H sensor does not connect to the ECC800 properly, check whether the cable
between the T/H sensor and the ECC800 is connected properly, whether the T/H
sensor and ECC800 are running properly, and whether the input parameters are the
consistent with the T/H sensor parameters.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 2 Switch 3
OFF OFF
ON OFF
ON OFF
OFF ON
Setting
Select T/H Sensor from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM4 from the drop-down list box.
In this example, set Device address to 1. Set the
actual device address of the T/H sensor during
operations.
5 Power-On Commissioning
Toggle Toggle
Switch 4 Switch 5
OFF OFF
OFF OFF
OFF OFF
OFF OFF
Toggle
Switch 6
OFF
OFF
OFF
OFF
116