Creating A Container Plan View - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

5.6 Creating a Container Plan View

Prerequisites




Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Click Create Container and set the layout and device quantity based on the actual container
scenario.
Step 3 Modify the container view.
1.
Modify Basic Config will clear the configured Container view. Therefore, exercise caution
when deciding to perform the Modify Basic Config operation.
2.
3.
Issue 06 (2020-01-02)
Devices in the container have been installed and cables have been connected. The
devices are running properly.
You have obtained the IP address of the ECC800 as well as the user name and password
used for WebUI login.
A PC with an IP address in the same network segment as that of the ECC800 is prepared,
and the PC has connected to port WAN_1 on the ECC800.
The system type is FusionModule1000A.
Choose Home > Plan View.
Click Modify Basic Config or Modify Device.
Modify the container view based on the actual situation.
When modifying the container view, you need to select a scenario (AIO-40FT-IT, AIO-40FT-CT, or
AIO-20FT-CT). The AIO-40FT-CT scenario is used as an example.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
120