Setting And Adding A Pmac625 Ac Meter - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 5-11 Adding an ATS
Path
System
Settings >
Device
Management
3.
----End

5.3.14 Setting and Adding a PMAC625 AC Meter

Prerequisites
The model of the three-phase AC power meter for the PDC is PMAC625.
In this example, a straight-through cable is used to connect the PMAC625 to the COM port on
the ETH converter.
When connecting devices, you are advised to add devices one by one and ensure that the view
is consistent with the real object. If all devices have been added and powered on, only the
BLINK function of the ETH converter can be used to identify the mapping between the
PMAC625 and ETH converter.
Procedure
Step 1 Set the PMAC625 communications address.
1.
Issue 02 (2019-02-28)
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the ATS connects to the ECC800 properly.
− If the ATS connects to the ECC800 properly, click Add Device.
− If the ATS does not connect to the ECC800 properly, check whether the cable
between the ATS and the ECC800 is connected properly, whether the ATS and
ECC800 are running properly, and whether the input parameters are consistent with
the ATS parameters.
Press on the displayed screen after the PMAC625 is started. Press
entering the programming mode. Modify the password (1 by default) in blinking ones
digit by pressing
Copyright © Huawei Technologies Co., Ltd.
Setting
Select ATS from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the ATS is connected to
the COM1 port on the ECC800. If the ATS is connected to
another port, enter the number of the connected port.
In this example, Device address is set to 1. During
actual configuration, set the device address for the
ATS based on the actual situation.
or , and press
5 Power-On Commissioning
to confirm the setting.
after
108