Huawei ECC800 User Manual page 139

ECC800 Data Center Controller
User Manual
Step 2 Add a water sensor.
In this example, the water sensor is connected to the COM1 port on the ECC800.
1.
2.
Table 5-28 Adding a water sensor
Path
System
Settings >
Device
Management
3.
Step 3 Set water sensor parameters.
1.
2.
3.
Step 4 Check functions of water sensors.
Table 5-29 Function commissioning
Check Method
Immerse the water detection
cable in water.
Issue 02 (2019-02-28)
Log in to the ECC800 WebUI as an administrator.
Add a water sensor.
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the water sensor connects to the ECC800 properly.
− If the water sensor connects to the ECC800 properly, click Add Device.
− If the water sensor does not connect to the ECC800 properly, check whether the
cable between the water sensor and the ECC800 is connected properly, whether the
water sensor and ECC800 are running properly, and whether the input parameters
are consistent with the water sensor parameters.
Log in to the ECC800 WebUI as an administrator.
Choose Monitoring > System > Water Sensor > Running Parameters.
Set the parameters based on actual conditions, and click Submit.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Water Sensor from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the water sensor is
connected to the COM1 port on the ECC800. If the water
sensor is connected to another port, enter the number of
the connected port.
In this example, Device address is set to 1. During
actual configuration, set the device address for the
water sensor based on the actual situation.
Normal Connection Status
 Choose Monitoring > System > Water Sensor >
Running Info. Check that Leakage status is
Alarm and Distance from the leakage point is
greater than 0 m.

Choose Home > Active Alarms. Check that a
Water Leakage alarm is generated.
5 Power-On Commissioning
130