Huawei ECC800 User Manual page 103

ECC800 Data Center Controller
User Manual
Device
Addre
ss
1
2
3
4
Step 2 Set monitoring parameters for the 6 kVA UPS2000-G or 10 kVA UPS2000-G.

Table 5-2 Setting a device address
Device
Addre
ss
1
2
3
4
Step 3 Add a UPS2000-G.
1.
2.
Table 5-3 Adding a UPS2000-G
Path
System
Settings >
Device
Management
Issue 02 (2019-02-28)
Toggle Toggle
Switch Switch
1 2
ON OFF
OFF ON
ON ON
OFF OFF
Operate the DIP switch S2 on the optional Modbus card to set the UPS2000-G device
address. Toggle switches 1 to 8 of DIP switch S2 specify the device address in binary
mode. ON indicates 1, and OFF indicates 0.
Toggle Toggle
Switch Switch
1 2
OFF ON
ON OFF
OFF OFF
ON ON
Log in to the ECC800 WebUI as an administrator.
Add a UPS2000-G.
Parameter
Name
Device type
Connect to
Communications
port
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle Toggle
Switch Switch Switch
3 4 5
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
Toggle Toggle Toggle
Switch Switch Switch
3 4 5
ON ON ON
ON ON ON
ON ON ON
OFF ON ON
Setting
Select UPS2000G-A from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM2 from the drop-down list box.
NOTE
The setting example indicates that the UPS2000-G is
connected to the COM2 port on the ECC800. If the
UPS2000-G is connected to another port, enter the
number of the connected port.
5 Power-On Commissioning
Toggle Toggle Toggle
Switch Switch Switch
6 7 8
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
Toggle Toggle Toggle
Switch Switch Switch
6 7 8
ON ON ON
ON ON ON
ON ON ON
ON ON ON
94