Huawei ECC800 User Manual page 133

ECC800 Data Center Controller
User Manual
2.
3.
4.
Step 2 Set running parameters for the AC actuator.
Table 5-22 Setting AC actuator parameters
Path
Monitoring > Aisle > AC Actuator
Group
Parameters
Step 3 Check the functions of the AC actuator.
Table 5-23 Function commissioning
Check Method
Path: Monitoring > Aisle > AC Actuator Group >
AC Actuator n
1. Choose Running Parameters, set Set light mode
2. Choose Controls, select Remote open scuttle,
----End
Follow-up Procedure
Set Set light mode is Automatic.
Issue 02 (2019-02-28)
steady green to blinking green at super short intervals (blinking at 10 Hz, on for 0.05
seconds and then off for 0.05 seconds). The ECC800 enters the wireless networking
(802.15.4) pairing status.
Hold down the BLINK button on the AC actuator for 2 seconds (1–5 seconds allowed).
The RF_Z indicator on the AC actuator turns from steady green to blinking green
intermittently at super short intervals (blinking at super short intervals for 0.5 second and
then off for 0.5 second). The component enters the wireless network search status.
After the wireless networking (802.15.4) pairing succeeds, the RF_Z indicator on the AC
actuator starts to blink at long intervals.
After all AC actuators are networked, hold down the SW button on the ECC800 main
control module for 2 seconds (1.2–5 seconds allowed). The RF_Z indicator on the
ECC800 main control modules turns from blinking green at super short intervals to
blinking green at long intervals (blinking at 0.5 Hz, on for 1 second and then off for 1
second). The ECC800 exits the wireless networking (802.15.4) pairing status.
If two or more ECC800 controllers need to be networked in wireless (802.15.4) mode, only one system
can be networked at one time. During the networking, ensure that the RF_Z indicators on the ECC800
main control modules of other systems are blinking at long intervals or steady on.
> AC Actuator n > Running
is Manual.
select ON, and click Submit.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Operation
Set Route 1 Control Mode to Light, and
click Submit.
Set Route 2 Control Mode to PAD
Charging, and click Submit.
Normal Connection Status
The light is on.
124