Setting Alarm Notification By Email And Sms - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
3.

5.5 Setting Alarm Notification by Email and SMS

The alarm notification by email and SMS is set as required. A maximum of 20 alarm
notification user information can be displayed.
Prerequisites
To implement alarm notification by SMS, the following conditions must be met:


To implement alarm notification by email, the following conditions must be met:

Procedure
Step 1 Choose System Settings > Alarm Notification.
Step 2 Set parameters in Alarm Notification Settings, click Test to test whether the email is sent
successfully. If the email fails to be sent, check the email parameter settings; if the email is
sent successfully, click Submit.
Figure 5-12 Sender's email settings
Step 3 Click Add in Alarm Notification User Info.
Step 4 Set Notification language, enter values for Email address and Mobile number, and set
Alarm severity. Click Test to test whether the short message is sent successfully. If the short
message fails to be sent, check the email and mobile phone parameter settings; if the short
message is sent successfully, click OK.
Issue 02 (2019-02-28)
Drag registered devices (for example, the camera) to the appropriate positions in the
layout diagram and click Exit Edit Mode. The smart module plan view is updated.
The ECC800 is configured with a 3G module into which a GSM or WCDMA SIM card
is inserted.
The SMS module is inserted into the USB port on the ECC800e and the SIM card is
inserted into the SMS module.
The ECC800 is connected to a network with mail servers through a WAN port. Both
Internet and local area network (LAN) can be used.
The ECC800 supports only SMS but not data services by using the 3G module.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
122