Huawei ECC800 User Manual page 24

ECC800 Data Center Controller
User Manual
Indicator
Wireless Network Pairing (SW) and IP Address Reset (Default) Buttons
Table 3-7 Wireless network pairing and IP address reset buttons
Button
Name
SW
Issue 02 (2019-02-28)
Color Name
Red Fault indicator
Function Operation Description
Description
Wireless In non-wireless network (802.15.4)
network RF_Z pairing mode, press and hold down
(802.15.4) the button for 1.2s to 5s to enter the
pairing wireless network pairing mode.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 1.2s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
Press and hold down the button for
more than 6s to clear network
parameters.
Copyright © Huawei Technologies Co., Ltd.
Status Description
Blinking at The communication between
long the converter and the outside
intervals is interrupted (the indicator
blinks at 0.5 Hz, on for 1s
and then off for 1s).
Steady on The converter locks out due
to output overvoltage.
The converter delivers no
output due to internal faults.
Off The converter is working
properly.
3 Device Description
Indicator Status
The RF_Z indicator
is blinking at super
short intervals.
The RF_Z indicator
is blinking at long
intervals.
The RF_Z indicator
is on.
15