How Do I Set And Add A Pmac625 Ac Meter - Huawei ECC800-Pro User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
----End

8.1.7.18 How Do I Set and Add a PMAC625 AC Meter?

Prerequisites
One end of the straight-through cable has been connected to the RS485 port on
the PMAC625 AC meter, and the other end has been connected to the COM port
on the ECC800-Pro.
Context
●
●
Procedure
Step 1 Set the PMAC625 communications address.
1.
2.
3.
Issue 02 (2020-09-07)
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
The model of the three-phase AC power meter for the PDC is PMAC625.
When connecting devices, you are advised to add devices one by one. If all
devices have been added and powered on, only the BLINK function of the ETH
converter can be used to identify the mapping between the PMAC625 and
ETH converter.
Press on the displayed screen after the PMAC625 is started. Press
after entering the programming mode. Modify the password (1 by default) in
blinking ones digit by pressing
setting.
Figure 8-17 Programming screen of the PMAC625
Enter the communications address setting screen by pressing
and press to confirm the setting.
Select the place of the communications address value to be modified by
pressing or
from 1 to 247) by pressing
setting.
Copyright © Huawei Technologies Co., Ltd.
or
, modify the communications address value (ranging
or , and then press
, and press to confirm the
to save the
8 FAQ
or ,
284