Checking The System Type And Setting The Smart Module Name - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
5.2 Checking the System Type and Setting the Smart
Module Name
Context


Procedure
Step 1 Choose System Settings > Smart Module Settings, and check whether System Type is
consistent with the type of the smart module.
(Optional) If the system type is inconsistent with the type of the smart module, perform the
following operations. The system type FusionModule2000 is used as an example.
1.
2.
3.
4.
Step 2 Choose System Settings > Smart Module Settings, modify Smart module name, and click
Submit in the Site ID area.
Issue 02 (2019-02-28)
System type: FusionModule500, FusionModule800, FusionModule1000A,
FusionModule1000B, FusionModule2000, and FusionModule5000 can be selected based
on the actual project configuration.
Site ID: Site network fault alarms are sent to the specified mobile phone numbers of
maintenance engineers by SMS. After Smart module name is changed, the new site ID
will be displayed in the short message content (for example, XXX device
communication interruption) so that maintenance engineers will know the site where the
fault has occurred.
 By default, the system type displayed on the web page is the system type selected last time. Change
the system type as required.
 If the system type is changed, the monitoring software will restart and you can log in to the WebUI
again after 3 minutes.
Select FusionModule2000 from the System Type drop-down list box.
Click Submit in the System Type area.
Figure 5-1 Setting the system type
Go to the Re-authentication page, enter the login user name and password, and click
Submit.
Log in to the WebUI again to check that the system type has been changed.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
92