How Should I Add The Devices Accessed Through A Smart Eth Gateway Over Modbus-Mac To The Ecc800 Webui - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Follow-up Procedure
Choose Home > Plan View on the ECC800 WebUI, and drag the device to the corresponding
position in the Smart Module View pane based on the actual device layout.
9.1.20 How Should I Add the Devices Accessed Through a Smart
ETH Gateway over Modbus-MAC to the ECC800 WebUI?
Context
The device that supports Modbus-MAC can be automatically identified by the ECC800.
Figure 9-5 Network diagram
Procedure
Step 1 Log in to the ECC800 WebUI as an administrator, and check whether the device exists on the
Monitoring page.
The following is an example of confirming the access of a WiFi converter.


Issue 02 (2019-02-28)
If the device exists, and communication status is normal, the device has accessed the
ECC800 successfully.
Figure 9-6 Device accessed the ECC800
If the device does not exist, check that the cable is properly connected between the
device and the ECC800 and that the device and ECC800 are operating properly.
Copyright © Huawei Technologies Co., Ltd.
9 FAQ
209