Select The Program - Mitsubishi Electric CR750-Q Instruction Manual

About command protection
It is the function which protects deletion of the program, name change, and change of the command from
the operation mistake.
・ Protection information is not copied in copy operation.
・ In initialization operation, protection information is disregarded and execute initialization.
About data protection
It is the function which protects the variable from the substitution to each variable by registration of the posi-
tion data based on the operation mistake, change, and the mistaken execution of the program.
・ Protection information is not copied in copy operation.
・ In initialization operation, protection information is disregarded and execute initialization.

(6) Select the program

This function is possible at the software version 1.3 or later of T/B.
The program of step or automatic execution can be selected.
This function is same as
also the program number is displayed on "STATUS NUMBER" of the operation panel.
The operation method is shown in the following.
1) Select the program
Move the cursor to the program which select by the key [ ↑ ], [ ↓ ].
<FILE/EDIT> 1/
1 08-04-24 17:20:32 22490
2 08-04-24 14:56:08
3 08-04-24 13:05:54
4 08-04-24 13:05:54
EDIT POSI. 123
2) Setting of the program name (number)
Press the [FUNCTION]+[EXE] key of T/B. The confirmation screen is displayed.
<FILE/EDIT> 1/
1 08-04-24 17:20:32 22490
2 08-04-24 14:56:08
3 08-04-24 13:05:54
4 08-04-24 13:05:54
123
EDIT POSI.
Confirm the program name (number) currently displayed. If the function key corresponding to "Yes"
([F1]) is pressed, the program name (number) is selected.
If the function key corresponding to "No" ([F4]) is pressed, the operation is canceled. Each returns to
the program list display.
<PROGRAM SELECTION>
SELECT THE PROGRAM
INTO TASK SLOT 1. OK?
123
Yes
Selection of the program is finishing above.
"3.8.2Selecting the program No."
20 Rem 136320
694
2208
1851
NEW
COPY ⇒
20 Rem 136320
694
2208
1851
NEW COPY ⇒
No ⇒
3Explanation of operation methods
by the operation panel. After program selection
<FILE/EDIT> 1/ 20 Rem
1 08-04-24 17:20:32 22490
2 08-04-24 14:56:08
3 08-04-24 13:05:54
4 08-04-24 13:05:54
NEW
EDIT POSI. 123
The figure is the example which selected the program 3.
<PROGRAM SELECTION>
SELECT THE PROGRAM
INTO TASK SLOT 1. OK?
Yes 123
<FILE/EDIT> 1/ 20 Rem
1 08-04-24 17:20:32 22490
2 08-04-24 14:56:08
3 08-04-24 13:05:54
4 08-04-24 13:05:54
NEW
EDIT POSI. 123
Operating the program control screen 3-67
136320
694
2208
1851
COPY ⇒
No
⇒
136320
694
2208
1851
COPY ⇒