Removing The Separation Roller - Canon 1000 Service Manual

4. MECHANICAL SYSTEM

5. Removing the Separation Roller

1) Open the paper deck cover, and remove the
mounting screw [1]; then, remove the
separation roll assembly cover [2].
Figure 4-314A
2) Remove the mounting screw [3]; while
pushing down the separation roller pressure
roll [4], remove the separation roller assembly
[5] together with the support plate.
Figure 4-315A
3) Remove the resin E-ring [6] and the bearing
[7] from the front of the separation roller
assembly; then, pull out the separation roller
shaft [8] from the separation roller assembly to
remove the separation roller [9].
4-24
COPYRIGHT © 2001 CANON INC.
[2]
[1]
[5]
[3] [4]
[6]
Orientation of the Separation Roller
The separation roller rotates in a specific
direction.
1) When installing the separation rubber roller,
make sure that the marking shown in Figure 4-
317A is toward the coupling (rear of machine).
2) When installing the separation roller, make
sure that the rib provided for identifying the
direction on the roller collar is toward the front
of the machine.
E-ring Bearing
Front of machine
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
[9]
[7]
Figure 4-316A
Markings
Figure 4-317A
Rib for identifying
direction
Roller collar
Figure 4-318A
[8]
Coupling
Pin