Mounting The Belt Retaining Members - Canon 1000 Service Manual

5. INSTALLATION
F. Mounting the Belt Retaining Members
Step
1 Fit the protrusion of the top of the belt
retaining member into the T-shaped
opening in the bottom plate of the
machine.
2 Slide the belt retaining member toward
the center of the machine so that the 6-
mm dia. hole of the belt retaining
member and its corresponding 4-mm
dia. hole in the bottom plate match.
3 Using the M4x8 screws used to keep
the externals, secure the belt retaining
member to the base plate. Be sure to
tighten the screws while butting the belt
retaining member upward and toward
the center of the machine.
4 Likewise, mount the belt retaining
member to the right front, right rear, and
left rear.
5-20
COPYRIGHT © 2001 CANON INC.
Work
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
Protrusion
Belt retaining
member
Protrusion