Removing The Image Position - Canon 1000 Service Manual

16. Removing the Image Position

Correction Pattern Reading CCD
Unit
1) Remove the hopper left cover.
2) Slide out the separation charging assembly
[1], and remove the screw [2] to remove the
CCD unit cover [3].
[3]
Figure 4-1101-16
3) Slide out the transfer unit.
4) Free the harness [5] from the three wire
saddles [4].
5) Remove the screw [7], and remove the cable
support plate [6].
Figure 4-1102-16
COPYRIGHT © 2001 CANON INC.
[2]
[1]
[6]
[4] [5]
[5]
[7]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
6) Disconnect the two connectors [8] from the
front.
7) Remove the unit fixing screw [9], and remove
the image position correcting CCD unit [10].
[10]
Figure 4-1103-16
8) Remove the two screws [12], and remove the
rear cable fixing plate [11].
9) Disconnect the two connectors [13] from the
rear.
[13]
[12]
[12]
[11]
Figure 4-1104-16
After installing the image position
correction CCD unit, execute 'FUNC
> INSTALL (2nd screen) > REG-
APER (auto adjustment of pattern
reading position)'; then, turn off and
then on the power to execute image
position correction.
[9]
[8]
[8]
4-115