[1]
Figure 4-906C
6)
Using the S-B gap adjusting jig [6] (FY9-
3024), fix the blade metal plate [4] in place
with four screws [5].
[4]
[5]
[6]
Figure 4-907C
[6]
Figure 4-908C
COPYRIGHT © 2001 CANON INC.
[3]
[1]
Developing sleeve
[5]
[4]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
Points to Note When Adjusting the
S-B Gap
• Be sure to use the S-B gap adjusting jig
outside the image area of the developing
sleeve.
• Be sure to make adjustments only after
cleaning the toner off the developing
sleeve with lint-free paper.
• After making S-B gap adjustments, check
to make sure that the "go" side of the
adjustment jig can slide (but not the "not"
side) into the gap.
7)
Connect the connector, and install the
developing assembly upper cover.
4-89