Canon 1000 Service Manual page 456

7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
Collecting container
Figure 7-231
14) Remove the screw, and pull out the collecting
container shutter.
(At this time, check to make sure that the col-
lecting container opening is open.)
Figure 7-232
7-20
COPYRIGHT © 2001 CANON INC.
Location indicating mark
Fixing screw
Collecting container shutter
15) Select the 2nd screen of 'FUNC > INSTALL' in
service mode.
16) To collect all four developers, press 'RECV-4';
for each, press 'RECV-Y, -M, -C, -K'.
(The developer will be discharged into the col-
lecting container; the operation will finish in
about 2 min.)
17) When done, close the collecting container
shutter, and fit and tighten the screw.
18) Remove the collecting container.
19) Close the transfer unit.
20) Press 'SPLY-Y, -M, -C, -K' as appropriate for
the color to replace on the service mode
screen.
21) Check to make sure that the screw inside the
developing assembly has started to rotate.
22) Fit the funnel that comes with the starter in the
supply mouth of the developing assembly.
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Funnel
Figure 7-233