5. Primary Charging Wire Cleaning
The CLC1000 is equipped with an automatic cleaning mechanism for the primary charging wire. The
mechanism turns on to clean the wire under the following conditions:
• The temperature of the fixing assembly is 165°C or less when the power switch is turned on.
• When the cleaning mechanism is activated in user mode.
• When 5000 copies have been made since the previous cleaning operation.
DC controller PCB
Primary charging wire
cleaning motor
(M24Bk,C,M,Y)
When the control signal from the DC controller is M24FW=1, M24RV=0, the primary charging wire
cleaning motor (M24) is rotated clockwise for about 13 sec; then, when M24FW=0, M24RV=1, the motor is
rotated counterclockwise for about 13 sec.
This sequence of operations is the same for all colors.
COPYRIGHT © 2001 CANON INC.
Cleaning pad
Figure 3-525
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
3. OPERATION AND TIMING
Counterclockwise
Clockwise
Primary charging wire
3-101