Canon 1000 Service Manual page 331

In the case of the black toner main hopper
[9], remove the two drive gears* [10]; then,
disconnect one connector each [11], and
remove the two mounting screws [12] each.
* Pay attention to the E-ring, C-ring, and
internal parallel pin.
Figure 4-721A
Figure 4-722A
COPYRIGHT © 2001 CANON INC.
[9]
[10]
[11]
[12]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
• In the case of the sub hopper toner sensor
[13], remove the two mounting screws [14].
[14]
Figure 4-723A
[13]
[14]
4-77