Canon 1000 Service Manual page 288

4. MECHANICAL SYSTEM
4) Remove the two screws [4], and remove the
two positioning pins [5].
5) Shift the sensor plate [6] to the rear to remove.
Figure 4-324B
6) Remove the two E-rings [7].
7) Shift the two feeding roller 2 bushings [8]
toward the inside, and remove them together
with the shaft [9].
[8]
[7]
Figure 4-325B
4-34
COPYRIGHT © 2001 CANON INC.
[6]
[4] [5]
[4]
[9] [7]
[8]
8) Remove the two E-rings [10] (resin) and the
gear [11], and remove the feeding roller 2
from the shaft.
[10]
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 4-326B
The gear is fixed in place to the
feeding roller 2 shaft with a parallel
pin. Take care not to drop the pin.
[11] [10]